Page 2 of 2
Re: Miter Box
Posted: Thu Feb 26, 2009 9:11 am
by luvrbus
Manny, Eagle used 3 different mitre boxes if you can post a photo I can tell you how much oil each one takes. good luck
Clifford
Re: Miter Box
Posted: Thu Feb 26, 2009 11:39 am
by Boomer
Manny, in the picture of the dipstick I sent, you will notice a o-ring on the stick, this keeps oil from blowing back up the dipstick tube. There is a tiny hole in the plastic part which allows the box to breath. Fill and drain through the pipe plugs.
Re: Miter Box
Posted: Thu Feb 26, 2009 11:45 am
by Boomer
I found my Morse Gearbox lubrication bulletin. It says:
Model of gearbox Oil capacity
4M 1/4 pint
6M 1 quart
8M 2 quarts
12M 1 1/2 gallons
Manny, I will PM a copy of this to you.
Hope this helps
Re: Miter Box
Posted: Thu Feb 26, 2009 9:38 pm
by buscrazyinFL
Clifford I will try to take a pic tommorow or this weekend thanks. Mark thanks for the Emails. I will be working on my Eagle this weekend I hope.
Re: Miter Box
Posted: Sat Feb 28, 2009 9:22 pm
by buscrazyinFL
I went ahead and installed the fill tube in the miter box and that went well. Then I drilled a hole on the dip stick handle to let air out, like in Boomer's pic above. I did all this at the garage where I store my bus. Then tonight I brought my bus home so I can finish installing my cruise control tomorrow (that will be another project eagle post). Anyway, when I got home I opened the engine compartment and there was no oil spilled out anywhere.
Re: Miter Box
Posted: Sun Mar 22, 2009 5:54 pm
by buscrazyinFL
Ok, here are the pictures you asked for Clifford. Can you tell me how much oil this type of miter box takes?
Re: Miter Box
Posted: Sun Mar 22, 2009 7:58 pm
by luvrbus
Manny, I use 3.5 qts in mine your is the same.If you need a new breather for yours if the dipstick starts leaking I have a couple of new ones and will send you one.I have a couple more Eagles here now and will check the speedometers for the vin number and see if they have the number on the back and get back to you good luck
Clifford