Page 3 of 11
Re: John & Tara's 1982 Eagle Model 10
Posted: Tue Feb 16, 2010 11:57 am
by busdriver58
Great job!
Are you an electrical bus guy? every time I open the elctric panel door I feel some strange fears because I know anything about that.
Did you follow a book to do that or is only your experience?
Re: John & Tara's 1982 Eagle Model 10
Posted: Tue Feb 16, 2010 3:45 pm
by John Mellis
Julio,
I cannot claim that wonderful work as my own. Dan McMurphy of Mims, Fl did the rewire job amongst much other work on my Eagle.
Re: John & Tara's 1982 Eagle Model 10
Posted: Sun Apr 04, 2010 6:39 pm
by John Mellis
Re: John & Tara's 1982 Eagle Model 10
Posted: Sun Apr 04, 2010 7:48 pm
by rusty
Is that the same air brush you where using to paint that Deer
. Looks good keep up the good work Thank You for sharing.
Wayne
Re: John & Tara's 1982 Eagle Model 10
Posted: Sun Apr 04, 2010 8:49 pm
by ericbsc
Lookin good John. Little tip( I drilled a bunch of holes off a ladder. Next day my feet hurt to walk!! I switched to a roll around scaffold. It you don't have one remember, a bus can be an excuse to buy lots of tools. P.S. I think a safari theme inside might be in order!!!
Re: John & Tara's 1982 Eagle Model 10
Posted: Mon Apr 05, 2010 10:21 am
by John Mellis
Re: John & Tara's 1982 Eagle Model 10
Posted: Mon Apr 19, 2010 12:03 pm
by John Mellis
Re: John & Tara's 1982 Eagle Model 10
Posted: Mon Apr 19, 2010 7:55 pm
by Sunchaser Art
John & Tara-
Looking good. . .you're into the fun part of the project now when you can make it look pretty. Looks like a great job on the Filon siding and getting the cabinets rolling--it's great when a plan comes together.
Keep up the good work and have lotsa fun!
Art
Re: John & Tara's 1982 Eagle Model 10
Posted: Mon Apr 19, 2010 8:08 pm
by ericbsc
Looks like you are not gona be tin tentin at Palmetto cove!!! Tara's cabinet work looks great!!! Tell her to keep up the good work
Re: John & Tara's 1982 Eagle Model 10
Posted: Mon Apr 19, 2010 8:27 pm
by luvrbus
Looking good John I am looking at your door the hole under the window is that for a dead bolt ? If so that is a bad spot on a Eagle to install a dead bolt the door will flex going down the road and will crack been there done that.
good luck and keep up the good work
Clifford