I removed my E-6 valve (air dual brake valve) in order to make room for my AC Evaporator. I just reinstalled the valve and lost my markings for the port that the individual air lines attach to. I have the correct numbers on the air lines but am confused about air line # 34 & 14. On the Eagle Manual picture I am unable to tell which port connects with air line #34 or #14. I would like to know which of the two air lines is the closest to the floor board. If one of you could look under the valve and check, it would be very much appreciated. I sure don't want to hook up the air lines in reverse.
Ben
Announcement Block
As of 12/1/2021, a major update of the forum software was accomplished
Update: 3/7/2024: The Eagles email account at GoDaddy no longer works. I have set up a gmail account as a workaround: eaglesinternational.email at gmail.com
Registration is open to the public (*) and free from any cost or obligation. Please allow up to 36 hours for your application to be processed. If you have problems registering, please email me at: eaglesinternational.email at gmail.com
(*) spambots will be deleted -- only legitimate public applications will be processed.
Reminder: the "quick links" menu offers you the best navigation of this forum -- you need to be registered and logged in to see that menu.
As of 12/1/2021, a major update of the forum software was accomplished
Update: 3/7/2024: The Eagles email account at GoDaddy no longer works. I have set up a gmail account as a workaround: eaglesinternational.email at gmail.com
Registration is open to the public (*) and free from any cost or obligation. Please allow up to 36 hours for your application to be processed. If you have problems registering, please email me at: eaglesinternational.email at gmail.com
(*) spambots will be deleted -- only legitimate public applications will be processed.
Reminder: the "quick links" menu offers you the best navigation of this forum -- you need to be registered and logged in to see that menu.
Eagle brake valve (E-6)
-
- Club Member
- Posts: 9
- Joined: Fri Jan 30, 2009 11:32 pm
- FMCA #: F160527
- Bus Model: 1982, Eagle, Model 10
Detroit Series 60 DDEC 3, Allison World Transmission WTEK 2, Model HD4060P - Location: Camino, CA
-
- Club Member
- Posts: 1437
- Joined: Mon Oct 13, 2008 1:35 pm
Re: Eagle brake valve (E-6)
Hiya Ben,that be line # 34 leading to the Front tank pressure swich is the closest to the floor board should be a 90 fitting there,#14(rear tank low pressure switch)on the bottom straight into the body.Hope it helps,sorry for the wait
-
- Club Member
- Posts: 9
- Joined: Fri Jan 30, 2009 11:32 pm
- FMCA #: F160527
- Bus Model: 1982, Eagle, Model 10
Detroit Series 60 DDEC 3, Allison World Transmission WTEK 2, Model HD4060P - Location: Camino, CA
Re: Eagle brake valve (E-6)
Hi Van, thank you for the prompt response. I did not expect an answer so soon. Thank you again.
Ben
Ben